46 CHAPTER 2: INSTALLING THE SWITCH
CAUTION: The dual personality ports on the Switch 5500G-EI enable you
to activate an RJ-45 port or an SFP port or a mixture of both (for example,
on the 24 Port Switch, you can activate the RJ-45 ports 23 and 24 and
the SFP ports 21 and 22 at the same time). If you try to activate the same
dual personality RJ-45 port and SFP port (for example, RJ-45 port 23 and
SFP port 23 at the same time), the SFP port will take priority.
Figure 15 Inserting an SFP Transceiver
5 Check the LEDs on the front of the Switch to ensure that it is operating
correctly. Refer to “
LEDs” on page 20 for more information.
Removing an SFP
Transceiver
If you wish to remove the transceiver (it is not necessary to power-down
your Switch):
1 Disconnect the cable from the transceiver.
2 Move the wire release lever downwards until it is pointing toward you.
3 Pull the wire release lever toward you to release the catch mechanism;
the transceiver will then easily slide out.
Product
label
Suitable port
on host Switch
To Next Page
Loading...
