3Com 5500G - Management Ethernet Port

Front Panel 11
Management Ethernet port
You can use the 10/100Base-TX management Ethernet port on the
OSN|M’s front panel for management only; not for exchanging data. Use
this port to log into the OSN|M’s Linux system through SSH, and then to
configure the Linux system. Refer to Table 3 for the management
Ethernet port specifications.
Interface standard EIA/TIA-232
Cable type Asynchronous serial port cables
Baud rate (bps)
■ 300
■ 1200
■ 2400
■ 4800
■ 9600 (default)
■ 19200
■ 38400
■ 56000
■ 115200
Table 3 Management Ethernet port specifications
Specification Description
Connector type RJ45
Number of connectors 1
Interface standard IEEE 802.3u
Cable type Category 5 cables (forward compatible)
Working mode
■ Full/half duplex
■ 10/100 Mbps autosensing
Supported frame format
■ Ethernet_II
■ Ethernet_SNAP
Table 2 Console port specifications
Specification Description