5-3
l Figure 5-4 Configure the same channe
Select 11 in the Channel drop-down list.
# Enable 802.11n (2.4GHz) radio. (By default, 802.11n (2.4GHZ) radio is enabled. Therefore, this step
is optional. )
Select Radio > Radio Setup from the navigation tree to enter the Radio Setup page. Make sure that
802.11n (2.4GHz) is enabled.
4) Enabling WDS
Select Wireless Service > WDS from the navigation tree to enter the WDS Setup page shown in
Figure 5-5.
Figure 5-5 WDS setup page
Select the check box corresponding to 802.11n (2.4GHz) and click Enable.
5) Configuring the access service
To Next Page
Loading...
