Throw in plastic parts and wait until the part is processed into
granulate.
Turn the machine off and open the interlock guard to slide out the
granulate collector.
3.3. PREPERATION INSTRUCTIONS
Before turning plastic waste into granulate. The following steps must be
taken:
Inspect the plastic parts for any impurities such as other types of plastic,
non-plastics or dust. Remove as much as possible to prevent any
damage to the machine and keep the output material as pure as
possible.
If SHR3D IT is used before with different materials, clean out the machine
first. More information about cleaning the machine can be found in
Chapter 3.4.5.
Break the material down to chunks that fit through the hopper opening.
The smaller the chunks, the easier the shredder can process the material.
To Next Page
Loading...