Quick Start Guide
7 Safety Instructions
7.1.
Power Disconnect Device
The plug on the power supply cord is intended to be the power disconnect
device. As a result, the power source (socket or outlet) shall be located near
the equipment and shall be easily accessible.
7.2. RF Safety
WARNING:
Part 90 Radiation Exposure Statement. The antennas used for this transmitter
must be installed to provide a separation distance of at least 1 meter from all
persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
Caution:
The 3M Toll RFID Reader 6204 UHF Reader is equipped with four (4) RF
ports. To prevent reader damage, active RF ports must be properly
terminated with a 50 ohm load or a functional UHF antenna before power up.
UHF Readers are factory configured to operate on RF port 1. As a result, port
1 must be properly terminated before initially powering on the reader. Before
activating any additional RF ports, they must also be properly terminated.
Never power up the reader unless the appropriate loads or antennas are
connected. Always power down the reader before removing an antenna or
load from an RF port.
7.3. Electrostatic Discharge
ATTENTION
3M Toll RFID Reader 6204 antenna ports may be susceptible to
damage from static discharge or other high voltage. Use proper
Electrostatic Discharge (ESD) precautions to avoid static discharge
when handling or making connections to the 6204 reader antenna or
communication ports. Equipment failure can result if the antenna or
communication ports are subjected to ESD.
7.4. Regulatory Compliance
Caution:
The 3M Toll RFID Reader 6204 is designed to meet the regulatory
requirements in those jurisdictions in which it is offered. Changes or
modifications not expressly approved by 3M for compliance could void the
user's authority to operate the equipment.
To Next Page
Loading...