To Next PageTo Next PageWhat to do if neither lamp nor fan comes on in 3M Projector?
If neither the lamp nor the fan comes on in your 3M Projector, ensure the projector is plugged into a power source. If it is, there may be an obstruction in the fan or motor, requiring professional servicing.
How to fix a 3M Projector when the lamp doesn't come on but the fan runs?
If the fan runs but the lamp doesn't come on in your 3M Projector, the lamp may be burned out and needs replacement. Alternatively, ensure the lamp is fully seated in the socket or that the lamp changer door is completely closed.
What to do if the fan doesn’t run, but lamp is on in 3M Projector?
If the lamp is on but the fan isn’t running in your 3M Projector, plug the projector into a power source. If it is already plugged in, the fan or motor might be obstructed, and you should have the machine serviced.
Why does a new lamp burn out immediately in my 3M Projector?
If a new lamp burns out immediately after turning on your 3M Projector, it could be a defective lamp or an electrical problem. Try one more lamp. If the second lamp also blows, have the machine checked by a qualified technician.
How to fix a 3M 9550 Projector image that is wider at the top?
If the projected image is wider at the top with your 3M Projector, check the power supply and ensure it is properly connected. Also, make sure the top cover is completely closed. Finally, reposition the screen surface to be 90 degrees to the projected image.
What to do if new lamp lasts less than 2-5 hours in 3M 9550 Projector?
If a new lamp lasts only a short time (more than one minute but less than 2-5 hours) in your 3M Projector, the lamp may be defective. Replace the lamp with a new one.
Why are the bottom or sides of projected image not in focus on 3M 9550?
If the bottom or sides of the projected image are not in focus on your 3M Projector, the lamp may not be the proper type. Replace it with the correct type of lamp.
What causes red or blue corners on a 3M 9550 Projector image?
If the corners of the projected image appear red or blue on your 3M Projector, the optical components may be misaligned. Have the optical components adjusted by a qualified technician.
General
