3M DX70i - Page 161

© 2008 3M 3M™DX70iデジタルプロジェクタ製品安全ガイド 161
日本語
ランプ カ ートリッジ を 交 換してくだ さい 。
The projector keeps track of the lamp usage. It will show you a warning
message:
When you see this message, change the lamp as soon as possible. Make sure
the projector has cooled down for at least 30 minutes before changing the
lamp.
Warning: Lamp compartment is hot! Allow 30 minutes to cool down before
changing lamp!
1. Turn off the power by pressing the Power/Standby button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Push up and remove the cover.
ランプカートリッジの交 換