3M Peltor Comtac V - ARC Helmet Attachment to Headband Conversion; Reattaching Components for Headband Conversion

13
F:26F:25 F:27
ARC Helmet Attachment / Headband Conversion Instructions
1. Rotate the right earcup (the one without the boom microphone) and detach the earcup arm
guide as shown in G:1 and G:2. Mild force is required. Repeat G:1 for the other guide, and
the helmet attachment should be removed. At this stage the earcup should look like in G:3.
2. Detach the boom microphone connector from the connector jack on the left cup as shown
 LQ*DQG)LJ*
3. Rotate the left earcup and detach the boom microphone earcup arm guide as shown in
G:6 and G:7. Mild force is required.
4. Repeat G:6 for the other guide, and the helmet attachment should be removed. At this stage
the earcups should look like G:8.
 5RWDWHWKHERRPPLFURSKRQHHDUFXSDUPJXLGHDQGDOLJQLWVRLWUHOHDVHVZLWKUHODWLYHHDVH
from the helmet attachment as shown in G:9 and G:10.
NOTE: Make sure you rotate the boom microphone earcup arm guide as shown in the figures,
because of the earcup arm guide lock when positioned in place.
6. Attach the boom microphone arm guide on the headband by rotating the arm guide and
align it so it fits with relative ease as shown in G:11 and G:12.
NOTE: Make sure you rotate the boom microphone earcup arm guide as shown in the figures,
because of the earcup arm guide lock when positioned in place.
F:29
F:30
F:28
Rendered on 1/23/2020 10:54:14 AM
Page 13
34-8725-1903-7 ComTac V manual.pdf