3M Peltor Comtac V - Troubleshooting Common Issues; Resolving Headset Power Problems; Addressing Communication Transmission Failures

19
TROUBLESHOOTING
Problem Possible Causes Suggestion
Headset will not
power on
Drained batteries Replace batteries
Battery improperly
installed
Check polarity
I can hear radio
communications
but cannot
transmit
Poor headset and PTT
connection
Ensure the headset plug is fully seated by
¿UPO\LQVHUWLQJLWLQWRWKH377KRXVLQJDQG
rotating 180°
1RQIXQFWLRQLQJ377 If a "known good" PTT is available, swap with
the problem PTT. If problem is solved, replace
the problem PTT.
1RQIXQFWLRQLQJ
communications
(comms)microphone
(A:6)
Check the comms microphone connection
on the backside of the earcup. If problem
persists, replace comms microphone with
a "known good" microphone. If problem is
solved, replace comms microphone.
1RQ1$72ZLUHG377 &DOO07HFKQLFDO6HUYLFHDW
Have headset model, PTT model and radio
model available.
Rendered on 1/23/2020 10:54:14 AM
Page 19
34-8725-1903-7 ComTac V manual.pdf