3M Scotch Pro TL1306 - Page 4

5. Press the desired Heat Setting button.
The 3 mil setting should be used for
laminating standard printer paper or
lighter weight items. The 5 mil or 6 mil
setting should be used for photo paper,
business cards or other thick items.
6. Wait for the green Ready light to come
on, which indicates the laminator is
warm enough for use.
7. Insert the item to be laminated into a
Scotch ™ Thermal Laminating Pouch
so that your item is close to the sealed
edge of the pouch (Figures 2 & 3). Do not
cut the pouch if your item is much
smaller than the size of the pouch or the
pouch may jam inside the laminator. You
can trim the pouch after laminating.
8. Insert the sealed end of the pouch
(Figure 3) straight into the laminator inlet
(Figure 4). Hold the pouch until the
machine pulls it forward.
9. The laminated item will automatically
exit the outlet of the laminator (Figure 5).
Do not pull the pouch through the
laminator. If the pouch does not feed
correctly or jams, push pouch reverse
button located on the control panel to
reverse the pouch back out of the
laminator.
10. Remove the pouch after it has stopped
moving and allow the sheet to cool on a
flat surface. It may be necessary to
laminate thicker items twice to
completely seal the pouch.
11. When finished laminating, press the
Power button to turn off the laminator.
The laminator will turn itself off after a
period of time. When cool, store
laminator by returning input tray to its
initial stored position. The power cord
may be stored in the well on the bottom
by wrapping around the posts.
Sealed Edge
(Figure 5)