4
Download 70mai app
This product may be used in conjunction with the 70mai app. You
can download and install the app by scanning the QR code or
searching for “70mai” in your phone’s app store.
Note: Android 5.0 or iOS 11.0 or above is required to connect to
the dash cam’s Wi-Fi hotspot with a mobile phone.
Dash cam Wi-Fi hotspot information:
• Hotspot name: 70mai_M200_XXXX (check the label on the device for precise
hotspot name)
• Default password: 12345678
Please refer to the “App Connection” section for how to establish a connection.
Installation
First, install the electrostatic sticker. Paste the electrostatic sticker on the
recommended area of the front windshield. Press the sticker to remove air bubbles out.
Avoid the edge of the windshield and select the flat and smooth area for the installation.
Note: Keep the windshield clean and dry without liquid residue to prevent the sticker
from losing adhesion and dash cam from dropping.
Install the memory card. Insert the memory card into the memory card slot with its
contacts facing up.
Mount the dash cam. Paste the dash cam onto the electrostatic sticker.
Route the cables. Route the power cord to the vehicle’s power outlet and connect to
power. Start the car engine and the dash cam will automatically turn on.
Finally, adjust the camera angle. Bind the dash cam to the 70mai app following the
instructions in “App Connection” section. Adjust the camera angle based on the image
presented in the dash cam’s homepage.
To Next Page
Loading...
