A/DA APP-1 - Effects Loop Setup; Tuner Out and Tuning

To Next Page

To Previous Page

1’sOUTPUTjack.Ifyouwanttojustdrivetheamplifier,youcandoso

byswitchingthePREAMP+BOOSTswitchtotherightandtheFX

LOOPswitchtotheright,sotheonlyfunctionoftheAPP‐1isthe

BOOST.IfyouwantBOOSTandthe

FXLOOPengaged,settheFX

LOOPswitchtotheleftandthePREAMP+BOOSTswitchtotheright

position.

Effects Loop (FX LOOP) Setup



Theeffectsloopisadual‐bufferedloopsoth esignalfromtheAPP‐1

islowimpedancecapableofdrivingmanyeffectsboxeswithoutany

changeinsignalintegrity.Thereturnsignalfromyoureffectschainis

alsobufferedwithahighimpedancebufferthathasagaincontrol

so

youcanbalanceorbringbackanysignallossfromyoureffectschain.



TohelpsetuptheFXLOOPproperly,theAPP‐1hasswitchlabeled“FX

LOOP”toswitchtoswitchinorbypassthesignalthroughyour

effects.Thisisusedtotrimthelevelwiththe

“FXLOOPRTNLVL”

controlinordertooptimizeyoursignalpathandtobalancethelevels

ofthepreampandyoureffectsboxes.

Tuner Out and Tuning



TheTUNERjackontherearpaneloftheAPP‐1allowsyoutoconnect

yourTunerthroughanisolationbuffersothatitnevercolorsorloads

downyourguitarsignal.Italsoallowsyoutotuneatanytime,and

byswitchingtheTRUEBYPASSswitchtothefarright,youcantune

whileyourstageandhousesoundismuted.