TO REMOVE THE OIL TANK
Remove the Twinseat
Remove the frame shield. It is held in position by two large knurled and slotted screws.
Remove the oil tank drain plug and empty the tank.
Disconnect the oil feed and return pipes from the bottom of the tank by sliding the rubber
connectors down the pipes.
The tank is held in position by four brackets and nuts and bolts, two at the top, one at the
front, and one at the back.
Remove the nuts, bolts and washers, lift the tank away from the frame a few inches, and
disconnect the vent pipe. The tank is now free. To refit, reverse the foregoing
instructions.
To Next Page
