19
SEC. 11
OUTPUT TYPE
Modality of cash signal (for 00 version)
This function allows to choose the modality of cash signal through:
parallel, binary, Confida bynary.
In the parallel option the channels over n° 6 have to be readdressed
on the first 6. The binary mode allows to pass this limit.
In this case the exit n°6 is used as validation of the other 5 exits.
Entering the function with key “OK”, select the option with +/- and
confirm with “OK”.
SEC. 12
DISPLAY OPTION
Forward/reverse display (for 10 version)
This function allows control of the increase display (from 0 to the
sale price) or the decrement display (from the sale price to 0).
This function can be entered pushing the key OK.
If “OPTION DISENABLE” is displayed the increase function on
the display is set. If “OPTION ENABLE” is displayed, the
decrement function is set.
To change the modality push the key + and OK.
SEC. 13
TIME DISPLAY OPTION
Time display option (for 60 version)
When the display (RM924) is connected to the coin mechanism, the
display will show the amount inserted up to a credit being obtained.
Then the collected credits wiil be displayed. Following the credit
release, the display will show the credit lenght decrement. By means
of this function it is possible to delete the last visual display.
Enter the function through key “OK” and the display will show the
state of the option.
SEC. 14
RESET TYPE OPTION
External reset qualification (active or passive for 10 version)
This function allows set up of the coinmech for use with machines
having different resets. If “OPTION DISENABLE” is displayed, the
coinmech works with a passive reset (line 6) due to power failure.
If “OPTION ENABLE” is displayed, the coinmech works with the
active reset (line 8), that is with a reset which is carried out by a
pulse of phase on line 8 of the coinmech (reset -> high level).
To Next Page
Loading...