5
WARNING SIGNALS
The warning signals during the process of different functions are:
“SERIAL ERROR” – “CLONING ERROR”
The first refers to a wrong writing in the coinmech, the second to
an error during cloning process.
In both cases try to switch off and on the coin mechanism.
If the message still remain check the connector of the programmer.
NOTE: In case programmer’s display shows anything check as
follows:
a) the coin mechanism is properly supplied
b) the connection between Programer and coin mechanism
Connection to RM3 coin mechanism
The PROGRAMMER can not be connected to RM3 coin
mechanism
To Next Page
Loading...