Need help?Do you have a question about the A.W. Sperry Instruments DSA-2002P and is the answer not in the manual?
General| DC Current Ranges | 200µA, 2mA, 20mA, 200mA, 10A |
|---|---|
| Diode Test | Yes |
| Continuity Test | Yes |
| Battery Test | 1.5V, 9V |
| Power Supply | 9V Battery |
| Display | 3-1/2 digit LCD |
| DC Voltage Ranges | 200mV, 2V, 20V, 200V |
| AC Voltage Ranges | 200V |
| Resistance Ranges | 200Ω, 2kΩ, 20kΩ, 200kΩ, 2MΩ |
Specifies the ranges, resolution, and accuracy for AC current measurements.
Details the ranges, resolution, and accuracy for AC voltage measurements.
Outlines the ranges, resolution, and accuracy for DC voltage measurements.
Provides ranges, resolution, and accuracy for resistance and continuity checks.
Describes the DC voltage output proportional to AC current for recording.
Procedure to verify the instrument's battery level before use.
Ensures correct function selector and mode settings for accurate measurements.
Instructions for measuring AC and DC current using the clamp meter feature.
Steps for accurately measuring AC and DC voltage using the test leads.
Guide on measuring resistance and performing continuity checks.
How to freeze and retain the displayed measurement value for easy reading.
Information on the automatic power-saving mode to conserve battery life.
Details on outputting measurement data for recording devices.
How to switch between different measurement modes like Normal, Peak, and Continuity.
To Next Page
