A.W. Sperry Instruments DSA-2002P - Battery Replacement

―17―
WARNING
●To avoid electric shock hazard, make sure to set the function selector
switch to "OFF" and remove the test leads from the instrument before
trying to replace batteries.
CAUTION
●Do not mix new and old batteries.
●Make sure to install batteries in correct polarity as indicated in the
battery compartment.
NOTE
● If the instrument is powered on, but the display blanks or "BATT" is
shown on the display, replace the batteries.
①Set the function selector switch to the "OFF" position.
② Unscrew and remove the battery compartment on the bottom of the
instrument.
③Replace the batteries observing correct polarity. Use two new R6P
batteries.
④Replace and screw the battery compartment cover.
８．BatteryReplacement
Screw
Battery
Battery
compartment
cover