33
COMMAND
NAME
DESCRIPTION
No.
COMMAND SYNTAX
Command Argument 1
Argument 2
Argument 3 Argument 4
Response
K Factors
Applies a gas correction
factor to the currently
selected primary gas
calibration table.
(NOTE: does not work with
% F.S. engineering unit.)
See list of the internal
K-factors in the operating
manual.
9
K
D*(disable, sets K=1) KD
I (Internal K-factor) No argument
(enable previously set
internal K-factor)
KI,<value>,<Gas>
Gas Index (0 -35) KI,<Index>,<Gas>
U (user specified factor) No argument
(enable previously set
user K-factor)
KU,<value>
<value>
(decimal correction
factor) (0-1000)
KU,<value>
S (status)
SK, <Mode>, <Index>,
<Value> where:
Mode: D, I, U
Index: 0-35
Value: K-Factor value
To Next Page
Loading...
