Aalborg XFM Series - Page 38

35
UART Error Codes: 1 - Not Supported Command or Back Door is not enabled. 2 - Wrong # of Arguments. 3 - Address is Out of Range (MR or MW commands). 4 - Wrong # of the characters in the Argument.
5 - Attempt to Alter Write Protected Area in the EEPROM. 6 - Proper Command or Argument is not found. 7 - Wrong value of the Argument. 8 - Reserved. 9 - Manufacture specific info EE KEY (wrong key or key is disabled).
COMMAND
NAME
DESCRIPTION
No.
COMMAND SYNTAX Command Argument 1
Argument 2
Argument 3 Argument 4 Response
Maintenance Timer
Hours since last time unit was calibrated.
11 C
R (read timer)
<Value> (in Hours)
C(set timer to zero)
CC
Full Scale
Returns the full scale rated flow in L/min. (Note: This term is not multiplied by the current K factor)
12
E
<Value> (in L/min)
LCD Back Light
LCD Back Light control (0-100.0%) 0 - off 100 - Maximum Intensity
13
B 0 to 100%
B:<Counts> where: Counts (0 – 4095) B:<Value> where: Value (0 – 100.0)
No Argument <Current settings>
Read EEPROM Memory
Reads the value in the specified memory location.
14
MR 0000 to999
(Table Index)
<value>
Write EEPROM Memory
Writes the specified value to the specified memory location. Use Carefully, can cause unit to malfunction. (Note: Some addresses are write protected!)
15 MW 0000 to 999
(Table Index)
Value MW,XXX,<Value>
where: XXX=Table Index