A&D BM-5 - Page 104

102 BM series
BM-252 BM-200 BM-300 BM-500
Weighing capacity 250 g 220 g 320 g 520 g
Maximum display 250.00084 g 220.0084 g 320.0084 g 520.0084 g
Readability 0.01 mg 0.0 mg
Repeatability
(Standard deviation)
*3 0.03 mg 0.1 mg 0.2 mg
Linearity ±0.10 mg ±0.2 mg ±0.3 mg ±0.5 mg
Stabilization time
(Typical at
FAST )
Approx.
8 seconds
Approx. 3.5 seconds
Sensitivity drift ±2 ppm/°C (10 °C to 30 °C, Automatic self calibration: OFF)
Operating environment 5 °C to 40 °C, 85 % RH or less (No condensation)
Display refresh rate 5 times/second or 10 times/second
Environmental sensors
Resolution: Temperature ±1.5 °C, Humidity ±10 %, Barometric pressure ±10 hPa
Applicable range: 5 °C to 40 °C
Minimum unit
mass
0.1 mg
Counting
mode
Number of
samples
10, 25, 50 or 100 pieces
Minimum 100%
reference mass
10 mg
Percent
mode
Readability 0.01 %, 0.1 %, 1 % (Depends on the reference mass stored.)
Interface USB and RS-232C
External calibration
weight
200 g
100 g
50 g
20 g
10 g
200 g
100 g
50 g
300 g
200 g
100 g
50 g
500 g
300 g
200 g
100 g
50 g
Size of loading area for
weighing mm
Weighing pan:90
Micro tube holder: 12 (Option)
External dimensions 259(W) x 466(D) x 326(H) mm
Power supply &
AC adapter type
Power consumption: Approx. 30 VA (supplied to the AC adapter )
Confirm that the adapter type is correct for the local voltage and power
receptacle type.
Mass Approx. 10 kg
The operating environment with no excessive changes in ambient temperature and humidity, no
vibration and drafts, no influence by magnetic fields and static electricity.
The internal mass may change due to corrosion or other damage caused by the operating environment,
or due to aging. Check the internal mass periodically and correct the internal mass value if necessary.
*3: Repeatability using a 100 gram weight within the weighing capacity.