104 BM series
20.2. Options and Peripheral Equipment
Ethernet Interface BM-08
The interface to connect the balance to a LAN.
Accessory: "WinCT-Plus" data communication software.
The software can acquire data from multiple balances
connected to a LAN.
The software can control these balances with commands.
The software can acquire data transmitted from balances.
Example: When pressing the PRINT key of the balance,
data is output and is acquired by the computer.
The stored data can be used with Microsoft EXCEL (if
installed).
Pipette Accuracy Tester BM-014
Note This option cannot be used for the BM-5
and BM-5D.
This option can be used to inspect the volume
dispensed from the pipette.
The accessory evaporation trap is used to prevent
the evaporation of the test liquid inside it.
The WinCT-Pipette software converts the test liquid
mass into a volumetric value.
Electrode Unit of the Ionizer AX-BM-NEEDLESET (4 pieces)
Use these electrode units for replacement parts of the
ionizer built into the balance.
Replace all four units with new ones at the same time.
Refer to "6.5. Ionizer " for the replacement.
Display Cover AX-BM-031 (5 pieces)
This option is the same as the accessory display cover.
Micro Tube Holder AX-BM-032 (for the BM-5/5D/20/22, standard accessory)
AX-BM-034 (for the BM-252/200/300/500)
This option is used when weighing with the general
micro tube or
test tube
under Φ
12 mm.
Note When using the micro tube holder for the
BM-5 and BM-5D:
The micro tube holder is approximately 2 g
heavier than the standard pan (weighing
pan and pan support). When a micro tube
holder is used for the BM-5 and BM-5D, the
available weighing range will be up to
approximately 3 g including the tare such
as a micro tube and test tube.
mL,
0 mL
Sample cup
Micro tube holder
Micro tube
Test tube
To Next Page
Loading...
