Alarm
Aastra 630d 71
eud-1095/1.0 – I7.8 – 07.2009
For your safety
■ Testing the alarm function
You can trigger a predefined test alarm to check whether the phone signals the alarms to the
alarm system and whether the system recognises the alarm signals and processes them.
This function is only available with an ATASpro licence. Contact your system administrator for
more information.
■ Range alarm
The phone can only send the alarm messages if it is within the radio area. So it is important to
activate the Range alarm so that you are notified acoustically by the phone if you are about to
leave the radio area (see chapter "Activating range alarm and system busy beep", page 45).
■ Battery alarm
For safety reasons make sure that the batteries are always loaded (see chapter "Charging the
battery", page 75).
When the alarm server mode is activated, an alarm is triggered as soon as the battery is below
20 %.
Note:
Always trigger a test alarm when you begin your shift to check that the alarm system is operational.
Repeat the test at regular intervals.
Press the navigation key to the right or the Menu softkey.
Settings
Scroll to Settings and press the Select softkey.
Sensor alarm
Scroll to Sensor alarm and press the Select softkey.
Transmit test alarm
Scroll to Transmit test alarm and press the Select softkey.
➔ Test alarm is sent to the alarm system. Depending on the configuration of
the alarm system, the alarm system triggers a test alarm and signals it on
your phone.
eud-1095_en.book Page 71 Monday, July 13, 2009 1:56 PM
To Next Page
Loading...
Need help?
General
