Installation and commissioning
Aastra 630d 75
eud-1095/1.0 – I7.8 – 07.2009
Battery
Take also note of the safety information on handling the battery set out in Chapter "Dealing with
batteries", page 8.
■ Inserting the battery
1. Undo the two screws on the back of the phone with a suitable tool (e.g. coin) and remove
the cover.
2. Insert the battery with the contacts downwards, close the battery compartment with the
cover and screw them together with an appropriate tool.
3. Do not damage the rubber seal during assembly.
■ Charging the battery
The batteries are supplied uncharged. To charge the batteries, place the phone in the charging
bay.
It is only after the battery has been charged for the first time that your phone is ready for use,
that calls can be answered and that you can make calls from the phone.
Notes:
• It takes several charging cycles before a new battery reaches full capacity.
• The technical data can be found in the Chapter "Technical Data", page 80.
• The descriptions of the display symbols can be found in the Chapter "Display symbols", page 4.
eud-1095_en.book Page 75 Monday, July 13, 2009 1:56 PM
To Next Page
Loading...
Need help?
General
