Page 5 01/2007 AMT/PTD/PBX/0062/1/2EN
1 INTRODUCTION
1.1 PURPOSE OF THIS DOCUMENT
This document describes how to install and put into service the DECT service on an IP network
associated with the following PBXs:
• NeXspan S/L/D (F6)
• NeXspan 50 and NeXspan 500 (F4)
• NCS (F5)
1.2 SCOPE
The IP DECT is applicable as of release 4.2 for the following PBXs:
• NeXspan S/L/D (F6)
• NeXspan 50 and NeXspan 500 (F4)
• NCS (F5)
1.3 AUDIENCE
This document is meant for installers whose tasks are to:
♦
♦
♦
Carry out a study into positioning base stations, and system traffic flow
Connect base stations
Start up the IP DECT system and put it into service.
1.4 REFERENCE DOCUMENTS
/1/ RFC 1350, The TFTP Protocol, Revision 2, July 1992
/2/ OpenMobility Generic Mobility Interface; KI: CTB005933
/3/ OpenMobility Matra Startup; KI: CTB006317
/4/ RFC 1156, Management Information Base for Network Management of TCP/IP-based internet,
May 1990
/5/ RFC 1213, Management Information Base for Network Management of TCP/IP-based internet:
MIB-II, March 1991
/6/ RFC 1450, Management Information Base for version 2 of the Simple Network Management
Protocol (SNMPv2), April 1993
/7/ http://www.simpleweb.org/ietf/mibs/index.html?sel=IETF
/8/ OpenMobility Diagnostic Tools
/9/ RFC 2131, Dynamic Host Configuration Protocol, March 1997
/10/ RFC 3164, The BSD Syslog Protocol, August 2001
To Next Page
Loading...
