AAVIK C-300 User Manual

output MC cartridges. The cartridge load impedance is adjustable in 18 steps
from 50 Ohm to 10 kOhm. Please see “1 Mute, O-set, Cartridge Loading
and Balance Settings” on page 4 for guidance.
LINE OUTPUTS
The C-300 amplifier is equipped with a single ended (RCA) and a balanced
(XLR) line output. Both outputs can be used simultaneously.
XLR pin-out:
Remote functions
14
A
D
D
D
D
E
F
G
D
F
C
E
G
B
2: + (non-inverting)
1: Ground
3: - (inverting)
Page 7
VOLUME UP
Press this button to increase the volume setting.
VOLUME DOWN
Press this button to decrease the volume setting.
INPUT +
Press this button, to move to the next input. From Line
1 to Line 2 etc.
INPUT -
Press this button, to move to the previous input. From Line 2 to
Line 1 etc.
STANDBY
Press this button to place the amplifier in standby mode, or to switch
the amplifier on from standby mode.
MENU
Use this button to cycle through the o-set, cartridge loading (when
the phono input is selected) and balance settings, and to return to
the volume setting. The light patterns of the volume display (4),
indicate which setting is active. The active setting can be changed
using the volume up/down buttons (A and B). You can read about the
dierent settings on page 4.
MUTE
Press the button to mute the outputs of the amplifier. A small
light beneath the mute button of the front panel will indicate that the
outputs of the amplifier are muted. Pressing the button again will
reactivate the outputs of the amplifier.
FACTORY RESET
You can reset all settings back to factory defaults. This will erase o-set
settings, the cartridge load setting, the balance setting and the remote
pairing settings. To do this, proceed as follows:
• Switch o the preamplier at the main power switch (10)
• Wait 30 seconds
• Press and hold the three front panel buttons (1), (2) and (3)
• Switch on the main power using (10), while still holding the front panel
buttons
• All LED indicators on the front panel will switch on, and stay on
• After approx. 8 seconds the LED indicators will switch o again.
• Release the front panel buttons, and switch o the preamplier using the
main power switch (10)

AAVIK C-300 Specifications

General

Brand	AAVIK
Model	C-300
Category	Amplifier
Language	English