5
6
SPEAKER TERMINALS
The amplifier accepts speaker cables terminated with
spade connectors and 4 mm banana plugs.
To connect speaker wires terminated with spades,
loosen the isolation knob and insert the spade be-
tween the isolator and terminal. Tighten the isolation
knob to secure the spade.
To connect speaker wires terminated with banana
plugs, insert the banana plug into the center hole of
the terminal.
7
PRE OUT
The amplifier is equipped with a set of pre out (pre-
amplifier output) connections. They can be used for
an active sub-woofer, a separate power amplifier or a
headphone amplifier.
For some uses, such as in combination with an head-
phone amplifier, you may need to mute the speaker
outputs, but not the pre outs. This can be achieved
by changing the “Pre Out Mute” setting. See “MENU
FUNCTIONS” for guidance.
8
LINE INPUTS
The amplifier is equipped with five single-ended, RCA
line inputs.
The gain of the line inputs can be changed to equalize
the volume of different signal sources. The range is
between 5 and 15 dB for input 1-4, and between 1 and
11 dB for input 5. The default gain for all inputs is 9dB.
Please see “MENU FUNCTIONS” for guidance.
9
POWER ON/OFF SWITCH
Toggle the switch to switch between fully off and
standby mode. When the amplifier is in standby mode,
the power consumption is less than 1W. When the
amplifier is on and idling, the power consumption is
less than 65W.
10
POWER INLET (CAUTION!)
The amplifier accepts mains voltages from 100 to
240VAC 50-60Hz.
The power inlet accepts power cables with an IEC
60320-C13 female connector.
To ensure the best performance, please consult your
Aavik Acoustics dealer for a suitable mains cable.
11
RS-232, FIRMWARE UPDATE
The amplifier RS-232 terminal is used for firmware
updates. You can check for firmware updates on the
Aavik Acoustics homepage.
12
TRIGGER OUTPUTS
The amplifier is equipped with two DC trigger out-
puts. These can be used to power-on power amps,
sub-woofers and other equipment together with the
amplifier. When the amplifier is switched on (not in
standby mode), the trigger outputs will supply 12VDC.
They can supply up to 80mA total.
REAR PANEL FEATURES
RS-232
TRIGGER
OUT
ON / OFF
100-240V AC
AMP
INTEGRATED AMP i·180
MADE IN DENMARK
PRE OUTLINE IN
1 2 3 4 5
RS-232
TRIGGER
OUT
ON / OFF
100-240V AC
INTEGRATED AMP i·280
MADE IN DENMARK
PRE OUTLINE IN
1 2 3 4 5
WARNING: To reduce the risk of fire or electric shock, do not expose the
amplifier to rain or moisture.
The lightning flash with an arrowhead symbol within an equilateral
triangle, is intended to alert the user to the presence of uninsulated
‘dangerous voltage’ within the product’s enclosure that may be of suffi-
cient magnitude to constitute a risk of electric shock to persons.
+
–
To Next Page
Loading...
