43
Technical Details
Projector not charging
Possible Causes Solution
There is no power. Check to ensure the power outlet source is good.
Check the power adapter to ensure a proper con-
nection with the wall outlet as well as the projector.
The projector is not set to the “OFF” Mode. Connect the power cord to the P400+. Connect the
other end of the power cord into the wall power
source. Toggle the “On/ O” switch to the “OFF”
Position.
When the projector is fully charged, the LED light
on the side of the projector will turn green. Allow
approximately 3-4 hours to fully charge the the
projector.
Troubleshooting
To Next Page
Loading...
