Technical Details
Chapter 5
IMAGE IS BLURRED
Possible Causes Solution
The Projector is not in focus Adjust the focus with the focus adjustment dial
until the image comes into focus
The Projector is offset from plane / angle of
operation
Move the projector so that it is both 180 degrees
and on an evern plane with the screen.
No Sync, No Signal
Troubleshooting
1. Be sure to setup the computer to enable a video signal output. On some
laptops this is done by pressing and holding Function F5 key. If using the
P5 as an external monitor on Windows based systems, this can be done
by selecting “extend my desktop to this monitor”. The native resolution
of the P5 projector is 1280x720. Depending on the video driver different
resolutions may need to be selected for proper output.
43
To Next Page
Loading...
