29
If the Ethernet cable is connected fine, it will display “Connect”. In this menu,
you can set IP address manually, also you can get IP address automatically.
" RED: Get IP address automatically.
" GREEN: Test the network if
connect correctly.
6.6.2 Connecting to the Wi-Fi
(Wireless LAN)
1. Plug in the wireless USB
dongle to the USB port.
2. Enter
Menu->SETTINGS->Wireless Setting->Search Access Pointer.
3. Select the network name of your Wi-Fi access point from the list.
4. Press the OK button, then input the right password. And you can press
YELLOW button to disable/enable the WI-FI.
5. Enter Menu-> SETTINGS->Wireless Setting->IP Setting.
If the Network is connected, it should get the correct IP address and display the
“Connect”.
6.7 USB Update
Menu-> SETTINGS ->USB update
USB Update can update software by using USB HDD or USB disk.
6.8 Network Update
Menu-> SETTINGS ->Network update
Network Update can update software by network.
To Next Page
Loading...
