GPS time synchronization module GTM
M14851-3 v5
This module includes a GPS receiver used for time
synchronization. The GTM has one SMA contact for
connection to an antenna. It also includes an optical PPS
ST-connector output.
IRIG-B Time synchronizing module
SEMOD141113-4 v9
The IRIG-B time synchronizing module is used for
accurate time synchronizing of the IED from a station
clock.
The Pulse Per Second (PPS) input is supported.
Electrical (BNC) and optical connection (ST) for 0XX and
12X IRIG-B support.
Transformer input module TRM
M14875-3 v10
The transformer input module is used to galvanically
separate and adapt the secondary currents and voltages
generated by the measuring transformers. The module
has twelve inputs in different combinations of currents
and voltage inputs. Either protection class or metering
class CT inputs are available.
Ring lug or compression type connectors can be
ordered.
High impedance resistor unit
M16727-3 v2
The high impedance resistor unit, with resistors for
pick-up value setting and a voltage dependent resistor,
is available in a single phase unit and a three phase unit.
Both are mounted on a 1/1 19 inch apparatus plate with
compression type terminals.
Layout and dimensions
IP14539-1 v1
Dimensions
IP14826-1 v1M15243-4 v7
IEC08000163 V3 EN-US
Figure 10. Case with rear cover
IEC08000165 V3 EN-US
Figure 11. Case with rear cover and 19” rack mounting kit
Generator protection REG670
1MRK 502 074-BEN M
50 Hitachi Power Grids
© Copyright 2017 Hitachi Power Grids. All rights reserved
To Next Page
Loading...
