ABB 500NMD20 Operating Instruction

ADVICE
If the running configuration (= running-config)
does not match the savedconfiguration (= startup-
config) it is lost with the restart.
ADVICE
All established communication connections will be
lost during restart.
Safety
DANGER
Interrupt the power supply before mounting or
dismounting the device.
WARNING
An easy to access manual interrupter has to be
installed into the power feed of the modem to be
able to disconnect the modem from the power
supply in the case of an emergency.
WARNING
The DC power supply has to fulfil the following
requirements in order to supply appropriate fire
protection:
•
Limited power source according to IEC 60950-1
or PS2 classified according to IEC 62368-1
•
Short-circuit current < 8A
WARNING
The device shall be powered off while accessing
any of the connectors X1 (power connector)or X2
(alarm relay). Any other connectors (e.g. Ethernet,
RS-232, RS-485or DSL) are hot-pluggable while the
device is operating.
WARNING
No plug shall be freely accessible in normal
operation due to safety reasons.

ABB 500NMD20 Specifications

General

Brand	ABB
Model	500NMD20
Category	Network Router
Language	English