Operation Manual / A130-M.. - A145-M..
9 Dismantling and fitting / 9.10 Removing the nozzle ring
© Copyright 2021 ABB. All rights reserved. HZTL4031_EN Rev.M January 2021
9.10 Removing the nozzle ring
Fig.52: Removing the nozzle ring
1. If present: Remove the metal C-ring(51105).
2. Position the fastening strips(51002) in place.
3. Pull out the nozzle ring(56001) with the two extraction devices(90070) and the service
support base(90012).
4. Remove the lamellar sealing ring (56005).
5. Remove the burst ring(57210).
Page 103 / 149
To Next Page
Loading...
