ABB Ability - Page 2

Items included in the ABB Ability™ Smart Sensor kit:
• 1 Loctite™ 3463 mounting putty (1 tube)
• 2 Receiving mount
• 3 Mounting bracket
• 4 Phillips head screws (2 qty) M4-0.7 X 10mm
• 5 Tapered hex head screw (1 qty) 1/4" x 5/8" (UNF 28)
• 6 ABB Ability™ Smart Sensor
Where to mount:
1. Sensor must be located between the drive-end and non-drive-
end bearings, as close to the center as possible. Note: The sensor
mount cannot be removed after installation.
2. For best Bluetooth® communication, mount the sensor with a
clear line of sight to any communication devices to be used: your
smartphone or a Bluetooth® gateway.
3. The mounting orientation must be such that the A-axis on the
sensor housing is parallel to the rotating shaft. If this is not
physically possible, the T-axis must be parallel to the rotating
shaft.
Installation instructions
WARNING: Direct skin exposure to solvents and/or mounting
putty could cause discomfort or injury, including but not
limited to burning or skin irritation. Use appropriate
protective gloves when following these instructions.
2 ABB ABILITY™ SMART SENSOR INSTALLATION INSTRUCTIONS
1
2
4
4
6
3
5
Supported motors
• This mounting instruction applies for fin-cooled motors up to frame sizes equivalent to IEC 450.
• Detailed information about which motor types can be monitored with the ABB Ability
TM
Smart Sensor can be
found on www.abb.com/smartsensor.
Additional items needed but not included in the kit:
• Degreasing agent
• Clean shop rag
• Rubber gloves
• Mechanical abrasive pad (i.e. sandpaper)
• Allen wrench (4 mm or 5/32")
• Small Phillips head screw driver
• Leveling tool
• Cutting tool
• Loctite™ Blue Threadlocker
Further information on Loctite
TM
3463 mounting putty is available from:
• Safety and technical data sheet for Loctite™ 3463 mounting putty are
available from: http://www.henkel.com
Items needed