Step 8
Secure mounting bracket to sensor mount using hex head screw.
If necessary, apply Loctite™ Blue or equivalent threadlocker to
threads of the hex head screw, and to the surface of the sensor
mount.
Step 9
Use a level to verify the alignment. The axial direction (white
line) must be parallel to the pump shaft. The tangential axis
(red line) should be at a right angle to the previous one, on a
plane tangential to the housing. The the radial direction (black
line) points towards the center line of the shaft.
If this is not possible, the T-axis must be parallel to the rotating
shaft.
Step 10
Use 2 Phillips head screws to securely fasten ABB Ability™
Smart Sensor to mounting bracket.
Next step
Digitally connect Smart Sensor using the ABB Ability™ Smart
Sensor app. Log on using your credentials and follow prompts
to connect.
9AKK106930A9455 01.2019
Step 7
A
ALLOW SUFFICIENT TIME FOR PUTTY TO HARDEN BEFORE PROCEEDING.
CURING TIME DEPENDS ON SURFACE AND AMBIENT TEMPERATURES.
TYPICAL CURING TIME IS 10 MINUTES, BUT THIS CAN TAKE LONGER IN
COLD ENVIRONMENTS.
T
R
A
—
For questions and support, please contact
ABB
Motors and Generators Service
Product information
www.abb.com/smartsensor
Support e-mail address
support.smartsensor@abb.com
NOTE
We reserve the right to make technical changes or modify the contents of this document without prior notice. With
regard to purchase orders, the agreed particulars shall prevail. ABB Ltd does not accept any responsibility whatsoever for po-
tential errors or possible lack of information in this document.
We reserve all rights in this document and in the subject matter and illustrations contained therein. Any reproduction, disclo-
sure to third parties or utilization of its
contents – in whole or in parts – is forbidden
without prior written consent of ABB Ltd.
Copyright© 2019 ABB, All rights reserved
CAUTION: REVIEW AND FOLLOW ALL MANUFACTURER’S INSTRUCTIONS
AND SAFETY PRECAUTIONS WHEN USING THREADLOCKER.
To Previous Page
Loading...
