ABB Ability - Page 38

6
ABB ABILITY
TM
EDGE INDUSTRIAL GATEWAY
38
Telit LE910-NA1 - North America version
6.2.4 Second antenna requirements (for antenna diversity)
Telit LE910-NA1 - North America version
Telit LE910C1-EU - Europe version
6.2.5 The MicroSIM card holders
The ABB Ability™ Edge Industrial Gateway includes the following MicroSIM card holders:
• 1st MicroSIM card holder:
• Integrated in a Combo MicroSD (push-pull) + MicroSIM (pull-lever) cards holder.
• Placed on the top side of the circuit board in the Service Panel.
• 2nd MicroSIM card holder:
• Push-pull card holder.
• Placed on the bottom side of the circuit board in the Service Panel.
Only the 1st MicroSIM card holder must be used for cellular connectivity.
How to insert / Remove the MicroSIM card
If you are using the holder on the top side of the circuit board To insert the MicroSIM card, complete the
following steps:
1. Orient the MicroSIM card with the contacts facing the circuit board and the cut corner - highlighted
with the letter A - facing the holder.
2. Push the MicroSIM card in the holder.
To remove the MicroSIM card, pull the eject lever: use a pen tip to simplify the operation:
Feature Value
Frequency range Depending by the frequency band(s) provided by the network operator
Bands See “Supported RF bands” on the previous page
Impedance 
Input power 
VSWR absolute max  
VSWR recommended  
Feature Value
Frequency range Depending by the frequency band(s) provided by the network operator
Impedance 
VSWR recommended  
Feature Value
Frequency range Depending by the frequency band(s) provided by the network operator
Impedance 
VSWR recommended  
—
Figure 8
—
Figure 9
A