ABB Ability - Installing on DIN Rail

ABB ABILITY
TM
EDGE INDUSTRIAL GATEWAY
53
8
—
8.3 How to install/remove the product on/from a DIN rail
8.3.1 How to install the product on a DIN rail
Prerequisite: Replace the Mounting Bracket with the DIN Rail Mounting Clip To install the product on a
horizontal DIN rail, complete the following steps:
1. Hook the upper mobile latches of the DIN Rail Mounting Clip on the upper edge of the DIN rail.
2. Push the product against the DIN rail. The lower latches of the DIN Rail Mounting Kit are locked on
the DIN rail.
8.3.2 How to remove the product from a DIN rail
To remove the product from a horizontal DIN rail, complete the following steps:
1. Push downwards the upper mobile latches of the DIN Rail Mounting Clip. The lower latches are
released from the DIN rail.
2. Pull the product out.
—
Figure 17
—
Figure 18
1
1
2
2