ABB Ability - Page 52

8
ABB ABILITY
TM
EDGE INDUSTRIAL GATEWAY
52
8.2.2 How to replace the DIN rail mounting clip with the mounting
bracket
To replace the DIN Rail Mounting Clip with the Mounting Bracket on the product, complete
the following steps:
1. Remove the 3 screws that hold the DIN Rail Mounting Clip in place.
2. Remove the DIN Rail Mounting Clip.
3. Place the 3 spacers (H = 4mm; Ext. diam. = 14mm; Int. diam. = 7mm) and the Mounting Bracket.
4. Tighten the 3 screws removed at step 1 by applying a torque of 0.7 Nm.
8.2.3 Which screws are used with the mounting bracket
or with the DIN rail mounting clip
The 3 screws that hold in place the Mounting Bracket or the DIN Rail Mounting Clip have the
following features:
• Phillips type H cross flat countersunk head screw KA35x12.
• Fully threaded.
• Stainless steel.
• Example of Manufacturer and Part Number: Bossard BN 13580 2000997.
—
Figure 15
Reference Value (mm)


T 
L 
ØD 
—
Figure 16
1 2
3 4