ABB Ability - Replacing Mounting Brackets;Clips

ABB ABILITY
TM
EDGE INDUSTRIAL GATEWAY
51
8
—
Figure 14
—
8.2 How to replace the mounting bracket
with the DIN rail mounting clip or vice versa
8.2.1 How to replace the mounting bracket with the DIN rail
mounting clip
To replace the Mounting Bracket with the DIN Rail Mounting Clip on the product, complete
the following steps:
1. Remove the 3 screws that hold the Mounting Bracket in place.
2. Remove the Mounting Bracket and the 3 spacers (H = 4mm; Ext. diam. = 14mm; Int. diam. = 7mm).
3. Place the DIN Rail Mounting Clip.
4. Tighten the 3 screws removed at step 1 by applying a torque of 0.7 Nm.
1 2
3 4