ABB Ability - Connecting to the Gateway

ABB ABILITY
TM
EDGE INDUSTRIAL GATEWAY
90
15
15
—
15.1 Connect
Warnings
Do not incorrectly configure the software, as this can lead to inaccurate data results.
Be sure that your laptop is connected directly to ETH1 of the EL Edge Gateway.
The ABB Ability™ Edge Industrial Gateway is configured using windows based ABB Provisioning Tool.
After installation of the tool and after the login the user will find a gateway configuration button called
"Configure the gateway". the user needs to connect to the gateway ETH0 port to configure it.
After clicking on "Configure the gateway" the automatic/manual discovery page appears
—
Basic configuration via provisioning tool