ABB ABILITY
TM
EDGE INDUSTRIAL GATEWAY
96
16
16
—
16.1 Configuration of the connections to web server
The FACTORY shipped device will have below configuration steps
A. Edge Gateway Web server is accessible on ETH1 5003 Port of the gateway.
B. Connect Ethernet cable from gateway’s ETH1 port to PC/Laptop ETHERNET port.
C. Edge Gateway default ETH1 IP address & subnet mask is:
IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
D. Setup ethernet at PC/Laptop (for local intranet access).
First connect the Edge Gateway to PC/Laptop with ethernet cable. In PC/Laptop, open the “Network
and Sharing Center” and then open the “Ethernet” network as shown below.
—
Annex 2: Web server Configuration
(Local view)
The web server is available only in Local view mode
To Next Page
Loading...
