ABB Ability - Page 97

ABB ABILITY
TM
EDGE INDUSTRIAL GATEWAY
97
16
16
Next, follow the steps in sequence of 1-7 as shown below:
1 – Open Properties in Ethernet Status window.
2 – open Internet Protocol Version (TCP/Ipv4) in Ethernet Properties window.
3 – select “Use the following IP address” option.
4 – set the ip address and subnet mask.
5 – Press “OK” button in Internet Protocol Version 4 (TCP/Ipv4) Properties windows.
6 – Press “OK” button in Ethernet Properties window.
7 – Press “Close” button in Ethernet Status window.
E. Install certificates & configure hostname in windows machine (please refer CSDG section no. )
Include if any certificate needed for CCT??
F. Link: https://xxx.elgateway.abb.local where xxx – is the last 3-digits of ABB device Serial number,
please check the label of the ABB Ability™ Edge Industrial Gateway for serial number.
G. Web server default credentials to login into Web Server
  
User Password: 12345678
H. Fill the details as per instructions in the web page – fill all details and accept the terms & conditions.
I. The default dashboard will appear.
 
• Add widgets in the dashboard.
• Create new users & roles.