R1…R4 Quick installation guide 21
10. Strip the control cable sheathing and twist the copper screen into a pig-tail.
11. Refer to page 27. Connect the ground screen pig-tail for digital and analog I/O
cables. (Ground only at drive end.)
12. Connect the ground screen pig-tail for Embedded fieldbus, EFB (EIA-485) cables at
X5. (Ground only at drive end.)
13. Strip and connect the individual control wires to the drive terminals. Tighten the
screws to 0.4 lb-ft (0.5…0.6 N-m).
WARNING! To avoid danger or damage to the drive on IT systems and corner
grounded TN systems, see section Check the compatibility with IT (ungrounded)
and corner-grounded TN systems on page 17.
To Next Page
Loading...
