AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B 173
4 Select the parameters to be changed, initiate the change with ENTER,
enter the change and save with ENTER.
5 Quit the menu with Back or Meas.
Replace one component with another component
1 Press softkey COMP. CONFIG. The "Configure Component" menu is
displayed with the component list.
2 Select the modules in the component list which is to be replaced by
another component.
3 Press softkey COMP. CHANGE. Enter password (level 3), as applicable.
The parameters of the component to be replaced are displayed.
To Next Page
Loading...
