Operating Instructions 22
CP600/Issue: 09.2011
CoDeSys MicroBrowser FAQ
I can not connect. It says “File Not Found!”
Possible reasons:
Some CoDeSys PLC's are case sensitive. Older versions of MicroBrowser CoDeSys get the entry
page with the name “PLC_VISU.xml” written in capital letters. But the file on the webserver is written
“plc_visu.xml”. Possible workaround: Modify the “webvisu.htm” file on your PLC and change this line:
<param name="STARTVISU" value="PLC_VISU"> to
<param name="STARTVISU" value="plc_visu">
How can I hide the menu bar and task bar?
Use the batch files KioskMode.bat to overwrite the uBrowser.xml with the prepared
uBrowser_Kiosk.xml, that has the tag <Kiosk> already set to “2” (full screen and always on top)
Copy the uBrowser.xml file from the Control Panel to a PC, change the tag <Kiosk> to “2” and copy it
back to the Control Panel.
The changes I made in the CoDeSys visualization are not updated on the Control Panel
If the Control Panel was already connected while changes are made in the CoDeSys PLC visualization
the MicroBrowser has to be restarted to update all views.
Update the MicroBrowser by repowering the Control Panel or exit the MicroBrowser and restart it e.g.
via File/New or File/Exit.
I changed the target system setting of my AC500 project. Now the webserver can not be
found any more.
After a change of target system in the Control Builder Plus the settings for the webserver are reset.
1. Open the settings CoDeSys/Resources/target settings/visualization.
2. Check Visualization and uncheck Inhibit download of visualization files.
Watchlists (Recipies) can not be saved or loaded
The MicroBrowser does not support watchlists.
To Next Page
Loading...
