Do you have a question about the ABB DW Series and is the answer not in the manual?
Manually switch relay channels on/off temporarily.
Lock relay channels in their current on/off state.
Enable random on/off switching at intervals.
Enable repetitive on/off switching cycles.
Create a new time program for the device.
Review existing programmed events and memory usage.
Change or remove existing time programs.
Copy programs between channels on DW2 models.
Erase all stored programs for a selected channel.
Turn the Bluetooth interface ON.
Turn the Bluetooth interface OFF.
Delete all settings except language and PIN.
Delete all saved time programs.
Delete all saved holiday programs.
Reset all channel counters.
Perform all resets and delete language/PIN protection.
Reset device for unexpected behavior, retaining settings.
Manually switch relay channels on/off temporarily.
Lock relay channels in their current on/off state.
Enable random on/off switching at intervals.
Enable repetitive on/off switching cycles.
Create a new time program for the device.
Review existing programmed events and memory usage.
Change or remove existing time programs.
Copy programs between channels on DW2 models.
Erase all stored programs for a selected channel.
Turn the Bluetooth interface ON.
Turn the Bluetooth interface OFF.
Delete all settings except language and PIN.
Delete all saved time programs.
Delete all saved holiday programs.
Reset all channel counters.
Perform all resets and delete language/PIN protection.
Reset device for unexpected behavior, retaining settings.