25/36
Fig. 17 (control box output)
F
Fig. 18 (quick connection)
7.2.2.2. Version: Internal connection
Every pole is linked to the control box with the “Umbilical Cord“. This shielded cable is prefabricated and factory
tested. This cable is generally pre-installed with the control box.
Allways disconnect the shielded multicore cable on the pole side
The free end of the cable is equiped with a multiple connector and must simply be connected to the pole. The
following figures shows the opened drive unit with the cable exit in position “X“and “Y”.
Fig. 19 Sorties de câble
HARTING Plug
Cable exit « X »
Cable exit « Y »
To Next Page
Loading...
