5/36
2. Introduction
The pictures and diagrams that are contained in this document are intended to illustrate this content and make it
as understandable as possible; they can differ from the contractual content of the materials
supplied through the use of different components and elements.
2.1. Improvement Policy
During the preparation of this document, we have placed special attention to understandability and
completeness.
It is our aim to continuously improve the quality of our documentation. We therefore welcome your opinion and
would be pleased if you would communicate suggestions for improvement to your local ABB or ABB Sécheron
representatives.
2.2. Notice
It is important that this document is stored in a safe place during the entire service life of the installation or
device; it should be passed on to any subsequent owners or operators. When ordering additional documentation,
please specify the corresponding reference number of the document, its revision and publication date.
2.3. Standards and Regulations
2.3.1. Device
The device conforms to the provisions of the following publications:
• EN 60694: Common Specifications for High-Voltage Switchgear
• EN 50152-1: Railway Applications; Fixed Installations – Particular Requirements for AC Switchgear -
Part 1: Single-Phase Circuit Breakers with Um above 1 kV
• EN 50152-2: Part 2
• EN 50124
• IEC 62271-100
2.3.2. Installation and Operation
For installation and operation, the corresponding pertinent provisions are to be taken into consideration, in
particular:
• HD 637: Power Installations exceeding 1 kV AC
• EN 50110-1: Operation of Electrical Installations
• Regulations for the prevention of accidents of the employer’s liability insurance associations or
comparable organisations
• Safety guidelines for auxiliary and operating materials
• Order-related specifications of ABB Sécheron
To Next Page
Loading...
