Need help?Do you have a question about the ABB SACE Tmax XT5 and is the answer not in the manual?
Manual detailing operation and maintenance for Ekip Touch Trip Units.
Safety requirements and warnings for installation, operation, and maintenance.
General pre-ignition inspections and checks before putting into service.
Routine inspections, cleaning, and fault management procedures.
Lists and describes the standard protections available for Ekip Touch models.
Describes available voltage protections like UV, OV, UV2, OV2, Phase sequence, VU.
Details advanced voltage protections: S(V), S2(V), RV.
Covers frequency protections: UF, OF, UF2, OF2.
Details power protections: RP, D, OQ, OP, UP, RQ, Cos φ.
Describes the ROCOF protection against rapid frequency variations.
Protection against motor block after startup.
Protection against motor block during startup.
Protects the motor in reduced or no load conditions.
Protects the motor in the event of phase loss.
Controls closing actuator based on synchronism conditions between sources.
Details standard measurements: instantaneous currents, events, trip, min-max, maintenance.
Covers measurements provided by the Ekip Measuring module.
Performance and characteristics of the Class 1 Power & Energy Metering package.
Describes the Datalogger function for recording data associated with trigger events.
Analyzes voltage and current controls over time, including harmonics and sags.
Covers main configuration parameters for Ekip Touch.
Describes test functions like Autotest, Trip Test, and Test CB.
Manages installation loads based on power consumption for efficiency.
Manages faults in installations with renewable energy sources.
Manual detailing operation and maintenance for Ekip Touch Trip Units.
Safety requirements and warnings for installation, operation, and maintenance.
General pre-ignition inspections and checks before putting into service.
Routine inspections, cleaning, and fault management procedures.
Lists and describes the standard protections available for Ekip Touch models.
Describes available voltage protections like UV, OV, UV2, OV2, Phase sequence, VU.
Details advanced voltage protections: S(V), S2(V), RV.
Covers frequency protections: UF, OF, UF2, OF2.
Details power protections: RP, D, OQ, OP, UP, RQ, Cos φ.
Describes the ROCOF protection against rapid frequency variations.
Protection against motor block after startup.
Protection against motor block during startup.
Protects the motor in reduced or no load conditions.
Protects the motor in the event of phase loss.
Controls closing actuator based on synchronism conditions between sources.
Details standard measurements: instantaneous currents, events, trip, min-max, maintenance.
Covers measurements provided by the Ekip Measuring module.
Performance and characteristics of the Class 1 Power & Energy Metering package.
Describes the Datalogger function for recording data associated with trigger events.
Analyzes voltage and current controls over time, including harmonics and sags.
Covers main configuration parameters for Ekip Touch.
Describes test functions like Autotest, Trip Test, and Test CB.
Manages installation loads based on power consumption for efficiency.
Manages faults in installations with renewable energy sources.
General| Standards | IEC 60947-2 |
|---|---|
| Frame Size | XT5 |
| Rated Operational Voltage (Ue) | 690 V |
| Number of Poles | 3, 4 |
| Protection Type | Thermal-magnetic |
To Next Page
