ABB | SACE Tmax XT
External accessories | 3 - Ekip Supply131 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
3 - Ekip Supply
Ekip Supply is an accessory supply module. It is available in two models, depending on the incoming voltage
to be provided.
It performs three functions:
• supplies auxiliary power to Ekip Touch
• allows the modules installed inside Ekip Cartridge to be connected to Ekip Touch
• acts as a bridge for the Local Bus between Ekip Touch and the external electronic accessories (e.g. Ekip
Signalling 10K and Ekip Multimeter)
The module has a Power led to signal the presence of incoming power supply:
• off: no supply
• on (steady): supply present
Electrical characteristics
Model
Ekip Supply
24-48VDC
Ekip Supply
110-240 VAC/DC
Power supply voltages 21,5 ÷ 53 VDC 105 ÷ 265 VAC/DC
Frequency -- 45 ÷ 66Hz
Maximum power consumption without modules
(1)
3 W 3 VA/W
Maximum power consumption with modules
(2)
10 W 10 VA/W
Maximum inrush current 2 A for 20 ms 2 A for 20 ms
(1)
Ekip Touch with just Ekip Supply
(2)
Ekip Touch with three modules connected with Ekip Cartridge
Connections
The module must be assembled in the first slot of Ekip Cartridge.
For references about the connection and terminals, please consult document 1SDM000005A1001; use AWG
22-16 cables with 1.4 mm maximum outer diameter for the external cabling.
To connect the module to Ekip Cartridge, please consult document 1SDH002009A1503.
To Next Page
Loading...
