ABB SACE Tmax XT5 - Ekip Com Devicenet

ABB | SACE Tmax XT
External accessories | 6 - Ekip Com DeviceNet TM137 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
6 - Ekip Com DeviceNet
TM
Ekip Com DeviceNet
TM
is a communication accessory which allows Ekip Touch to be integrated into a CAN
network with DeviceNet
TM
communication protocol, with remote supervision and monitoring functions.
The module is configured as a Slave and remotely, you can:
• read Ekip Touch measurements and information
• manage certain controls, including opening and closing the actuator
• access information and parameters not available on the display
• If connected to a withdrawable version of the circuit-breaker, the allows the racked-in/racked-out status
to be detected
NOTE: the remote open and close commands of the circuit-breaker can only be executed if
Ekip Touch is in the Remote configuration
The System Interface document is available for mapping the module in its communication network. All the
required communication and command details are listed in the document (page 129).
Accessories Ekip Cartridge and Ekip Supply are required in order to connect Ekip Com DeviceNet
TM
to Ekip
Touch (page 130, 131).
Models
Two different modules compatible with the DeviceNet
TM
protocol are available: Ekip Com DeviceNet
TM
and
Ekip Com DeviceNet
TM
Redundant.
The modules are identical in terms of characteristics and installation methods, except for: display menus,
cabling and addresses for system communication, which are specific for each module.
NOTE: if different indications are not given, the information in the next chapter is valid for
both models
The two modules can be connected at the same time to Ekip Touch so as to expand the potential of the unit
(e.g. for applications where high grid reliability is required).
IMPORTANT: each Ekip Touch can be fitted with only one module per type. The
configuration with two modules of the same model is not allowed (example: two Ekip
Com DeviceNetTM Redundant)
Connections
For references about the connection and terminals, please consult document 1SDM000005A1001; use
Belden 3084A type cables or equivalent for the external cabling.
To connect the module to Ekip Supply and Ekip Cartridge, please consult documentTo connect the module
to Ekip Touch, please consult document 1SDH002009A1503.
Power supply
Ekip Com DeviceNet
TM
is supplied directly by the Ekip Supply module to which it is connected.
To function correctly, the DeviceNet
TM
bus must be supplied on terminals V+ and V- with a signal of over 12
VDC.
NOTE:
• the ABB PLC with DeviceNet (CM575-DN) communication module provides V+ V- supply
• communication between Ekip Touch and the module is interrupted in the absence of power
supplies from Ekip Supply and on the supply terminals of the bus